Reprap Ramps 1.4 Kit

Reprap Ramps 1.4 Kit With Mega 2560 r3 + Heatbed mk2b + 12864 LCD Controller + DRV8825 +Mechanical switch +USB Cables For 3D Printer

Description:

• A simple steps and direction control interface
• Six different steps resolutions: full step, half step, 1/4-step1/8-step1/16-step, 1/32-step
• CAN interface directly with 3.3 V and 5 V systems
• Over-temperature thermal shutdown, overcurrent shutdown, undervoltage lockout
• Short to ground short circuit load protection
• 4 Layer 2 oz copper PCB, in order to improve heat dissipation
• Exposed solder ground below the bottom of the driver IC on the printed circuit board pad
• Module size, pin and interface matching A4988 stepper motor driver operators in many ways
• Adjustable current control lets you set a potentiometer, which lets you use the stepper motor\'s rated voltage or more, in order to achieve a higher rate of maximum output current step
• Intelligent chopping control automatically selects the correct current decay mode (fast decay or slow decay)
• Maximum 45 V supply voltage
• Built-in voltage regulator (the need for any external logic supply voltage)
• Best DIY 3D printer kit, build your own 3d printer kit

Package List:

• 1X MEGA 2560 R3
• 1X Ramps 1.4 Board Red
• 1X USB cable
• 5X DRV8825 module with heatsink
• 1X PCB Heatbed MK2B
• 1X 12864 LCD control panel
• 6X Mechanical switch with cable